FEATURES

 - Used latest Micro controller based technology
 - 5 Digit 7 segment bright red L.E.D. display.
 - Program setting by three soft membrane keys On the front panel.
 - Built in Preset Batch Counter in 4 digit.
 - Upto 34 Channel Independent Relay output.
 - RESET &HOLD function from front & backside.
 - Output 1NO/C/NCcontact rated 6A at 230VAC.
 - Built-in watch-dog circuit for fail safe operation.
 - Compact in size & easy to set & operate.
 - Non-volatile battery backup to hold the data in case of power failure.
 - Power fail three conditions programmable by users.

 Display
 Range

 Resolution
 Accuracy
 Time Base
 Setting
 Relay action
 Output
 Supply
 Mounting
 Dimension



 Cutout

 Cabinet
 Terminal
 Channel
 Mode
 Batch Counter
 Hold(IP1) :

 Reset(IP2) :
 Builtin :

 5 Digit of 13.0mm. bright L.E.D display.
 0-999 (3 digit) Sec / Min / Hour ON time programmable by users. 0-999 (3 digit) Sec / Min / Hour OFF time
 programmable by users.
 0.01, 0.1, 1 programmable by users for both time ON time and OFF time.
 Better than 0.01%
11.059MHz quartz crystal time base.
 By 3 keys on front panel i.e., (+), (-) & (SET) key.
 Programmable by selecting ON time or OFF time should start first.
 1NO/C/NC rated 6A at 230VAC for each relay.
 230V AC A10% 50Hz, 110V AC A10% 50Hz, 24V DC.
 Panel Mounting.
 96(W) X 48(H) X 120(D) mm. for PT-130-2 (2 channel)
 96(W) X 96(H) X 120(D) mm. upto PT-130-10 (10 channel)
 192(W) X 96(H) X 210(D) mm. upto PT-130-34 (34 channel)
 Cutout : 92(W) X 44(H) mm. (2 Channel)
 92(W) X 92(H) mm. (10 Channel)
 188(W) X 92(H) mm. (34 Channel)
 ABS Plastic, Black / White colour.
 18Nos. ‘L’ type connector for ‘Y’ type lugs.
 2 Channel to 34 Channel.
 Count Down mode, Count up mode.
 Built in preset cyclic counter will count number of cycle completed.
 Manual by pressing (+) key or remote hold from back panel terminal by shorting 'IP1', with (+V) terminal and
 short again both terminal to release the hold function as toggle switch function.
 Manual by pressing (-) key or remote reset from back panel terminal by shorting IP2 with (+V) terminal.
 +12VDC supply.