Data Scanner, Data Logger, Process Control Instruments, Gas Detection System, Humidity and Temperature Controller, Digital Meter, Flow, Transmitter, Counter, RPM, Oxygen Analyser, Pressure /  Vaccum Controller ambetronics logo
homeabout usproductsclientsContact Us

Goto Page : Product Category 

PIN 317 : PRESSURE / VACCUM CONTROLLER

 

Pressure Vaccum Controller Panel Mounting

pressure vaccum controller
Panel Mounting

Pressure Vaccum Controller - Weatherproof

pressure vaccum controller
Weatherproof

Pressure Vaccum Controller - Flameproof

pressure vaccum controller
flameproof

 
ILLUSTRATION
Pressure Vaccum Controller

    FEATURES

 - User Programmable With Password Protection & Password Changing Facility
 - Easy Programming With Front Panel Push Button Software Calibration
 - 4 Digit Dual L.E.D. Display ;
    CH-1:Upper Display For Indication Of Pressure In Any Units
    CH-2:Lower Display For Indication Of Pressure In Any Units
 - Resolution Of 0.001, 0.01, 0.1, 1; Programmable by user
 - Excellent Long Term Stability & Spike Protected
 - Two Relay O/Ps, One Each For CH-1 & CH-2
 - Adjustable Time Delay For Operation Of The Relay
 - Two 4 - 20 mA O/Ps, one each for CH-1 & CH-2
 - Isolated RS - 485 Communication With Modbus RTU Protocol

    APPLICATIONS

 - Industrial Controls
 - Pneumatic Controls
 - Medical Instrumentation
 - Barometry
 - Medical Equipment
 - Respiration
 - HVAC
 - Level Detection
 - Flow Measurement
 - Environmental Control
 - Volume OEM Application
 - Duct Static Pressure
 - Dust Collectors
 - Glove Box Pressure
 - Bubbler Systems
 - Cabinet Purging
 - Industrial Ovens

TECHNICAL SPECIFICATION

 Input
 Range
 Resolution
 Accuracy
 Displayv

 L.E.D. Indication

 Set point
 Hysterisis
 Control action
 Time delay
 Relay contact type
 Configuration of relay
 Fault condition
 Setting
 Monitoring
 
 Retransmission output

 Communication
 Supply Voltage
 Operating  Temperature
 Relative humidity
 Enclosure Detail
 Protection Class
 Cabinet Material
 Cable Entry

Dimension
Mounting
Weight

 2 NO x Pressure & Vaccum in Kg/cm2, mBAR, BAR / Kg, mmHg, mmH2O, PSI ; as per customer requirement
 As per the Input Pressure & Vaccum
 0.001, 0.01, 0.1, 1; as per customer requirement
± 0.25% of Full Scale
 Upper (CH - 1) : 4 Digit, 0.56” (13 mm), 7 segment GREEN L.E.D. display
 Lower (CH - 2) : 4 Digit, 0.56” (13 mm), 7 segment GREEN L.E.D. display
 L.E.D. Indication TD1 & TD2 for Time Delay, RL1 & RL2 for Relay, TX & RX for Communication, PRG to show ‘User’ in
 programming Mode
 2 No Independent set points, one each for RL1 & RL2 with programmable Latch & Non-Latch facility
 0 To 10, Individual setting for RL1 & RL2
 LO - HI, HI -LO, LO -Very LO, HI - Very HI; Programmable by user
 0 To 9999, Independent setting for RL1 & RL2 to operate after the ‘Process Value’ crosses the ‘Set point Value’
 1 NO/C/NC Relay contact rated 230 VAC / 5A For RL1 & RL2
 RL1 operates for CH-1, RL-2 operates for CH-2
 In ‘Under’, ‘Over’ OR ‘Open’ condition i.e. fault condition, Relay can be made OFF or ON; Programmable by user
 Setting by 4 keys on front panel i.e. ‘SET / NEXT’, ‘UP’, ‘DOWN’ & ‘BACK’
 By Display : Sensor ‘Break/Open’ shows ‘oPEn’, ‘Under’ range shows ‘Undr’ & ‘Over’ range shows ‘ouEr’
 By Retransmission current output : Up scale current : 21 mA, Down scale current : 3 mA; Programmable by user
 i) No of Current outputs : 2 No, 4 - 20 mA or 20 - 4 mA programmable with MAX load 750 ohms for CH-1 & CH-2
 ii) Range: - 999 to 9999, Low range / High range: Anywhere in the range (High range > Low range)
 Serial port: Isolated RS - 485 with Modbus RTU protocol ii) Slave ID : 1 to 247 iii) Baud Rate : 9600 / 19200
 230 VAC ± 10% OR 110 VAC ± 10% OR 24 VDC
 40 To 85°
 Below 95% non condensing
 PANEL MOUNTING (PM)                WEATHERPROOF (WP)                       FLAMEPROOF (FLP)
 IP - 40                                             IP- 65                                                 IP - 65 for Gas Gr. IIA & IIB
 ABS Plastic,                                    Black / White Colour Polycarbonate,  Grey colour
 Terminal connector                        Thermoplastic cable gland (IP - 68)    Cast Al. alloy, LM-6 / C.I. Enclosure, Double
  for connection                                                                                          compression cable gland (Ex-Proof)¾” ET-type
 96 (H) X 96 (W) X 120 (D) in mm    255 (H) X 240 (W) X 120 (D) in mm     300 (H) X 250 (W) X 110 (D)
 Panel mounting                             Wall Mounting / Stand Mounting        Wall Mounting / Stand Mounting
 Approx. 1.0 Kg                               Approx. 2.5 Kg                                     Approx. 4.0 Kg

Goto top PDFDownload Catalog
 

HOME   |   ABOUT US   |   PRODUCTS   |   CLIENTS   |   CAREER   |   ENQUIRY   |   CONTACT US

© AMBETRONICS Engineers Pvt Ltd, India. All Rights Reserved Jan 2009 Email: